Honeywell CIPer 30 - Installation Instructions Manual

® U.S. Registered Trademark
Copyright © 2020 Honeywell Inc. ▪ All Rights Reserved
31-00319-02
CIPer
TM
Model 30 Expansion IO Modules
INSTALLATION INSTRUCTIONS
Introduction
The CIPer Model 30 Expansion IO (EXPIO) are part of the CIPer family. The CIPer Model 30 programming model
allows user to connect extra input and output connections along with the on-board IO connections. The I/O points
which user can add externally as an expansion to existing on-board points are called as expansion I/O points.
The CIPer Model 30 Expansion IO (EXPIO) modules are available in two models as described in the table below:
Devices
UI
BO
UIO
WEB-O9056H
9
6
5
WEB-O3022H
3
2
2
Each device is programmable because the user chooses which function blocks to use and how to connect them. It
is configurable because each function block has user- defined behavior.