Need help?Do you have a question about the Honeywell CIPer 30 and is the answer not in the manual?
General| Ethernet Ports | 2 |
|---|---|
| Power Supply | 24 VAC/VDC |
| Protection Class | IP20 |
| Communication Protocol | BACnet/IP, Modbus TCP |
| Storage Temperature | -40°C to 70°C |
| Relative Humidity | 5% to 95% (non-condensing) |
| Communication Interface | RS-485 |
| Certifications | CE, UL |
Lists other documentation for the CIPer Model 30 controller and related systems.
Defines technical terms and acronyms used in the guide.
Details the necessary software versions and configurations for the programming tool.
Lists compatible operating systems for installing the CIPer Model 30 programming tool.
Specifies compatible web browsers for accessing the controller's interface.
Outlines the essential requirements before beginning the installation process.
Explains how to install, upgrade, or manage licenses and certificates for the controller.
Introduces the methods for upgrading controller software and firmware.
Lists the specific .dist files needed for the Distribution File Installer method.
Provides a step-by-step guide for using the Commissioning Wizard for upgrades.
Details how to configure and use the Niagara Provisioning Service for mass upgrades.
Steps to confirm the correct baseboard firmware version after upgrade.
Steps to confirm the firmware version of connected Expansion IO modules.
Instructions on how to launch the Niagara N4 application and workbench.
Specific instructions to launch Niagara N4 via the taskbar application list.
Details required cable connections and the function of controller ports.
Provides the default IP address, username, and password for initial access.
Step-by-step guide to configure the controller's platform settings.
Steps to start and configure the controller's station.
Instructions for setting up network communication via Ethernet.
Instructions for establishing communication via a serial connection.
Procedure to restore the controller to its original factory settings using a serial connection.
Detailed steps to configure RSTP properties using the Niagara workbench.
To Next Page
