TM
MODEL 30 CONTROLLER - INSTALLATION AND OPERATIONS GUIDE
27 31-00206 - 02
Configuring CIPer Model 30 Controller with WEBStation
Once you installed WEBStation-N4-4.x.x.xx on your system, you can start configuring the controller
with the WEBStation. Connect all the required cables to the controller as shown in the figure.
Cable connections:
1. Power Cables
2. Ethernet Cable
3. Serial Communication Cable
Left Side view of the CIPer Model 30 controller.
Ports Details:
1. Ethernet Ports – 1 to 4
2. Serial Communication Port – 5
Right Side view of the CIPer Model 30 controller.
To Next Page
Loading...
