TM
MODEL 30 CONTROLLER - INSTALLATION AND OPERATIONS GUIDE
25 31-00206 - 02
Launching Niagara N4
Launching Niagara N4 from desktop
1. Run the Niagara application from your system as an administrator user.
Launching Niagara N4 from application folder
If you didn’t find Niagara application launcher on your desktop.
1. Navigate to the Niagara bin folder (Navigation path: C:\Honeywell\WEBStation-N4-4.7U1\bin,
where U1 indicates latest version of the Niagara N4), locate wb.exe file, and run the wb.exe file
as an administrator.
2. Perform the following steps if you have more than one version of Niagara installed on your
computer to make sure the right Niagara daemon is running.
3. Right-click the console in the Niagara bin folder and click Run as Administrator.
4. On Administrator: Niagara Command Line window, run the command plat installdaemon, and
press the Enter key. The daemon is installed and started.
5. Enter wb and press the Enter key to start the Niagara workbench after successful installation
and starting up the daemon.
On successful execution of the wb command the Niagara WEBStation N4 home screen is
displayed as shown in the below figure, WEBStation N4 Home.
Important: It is recommended to use latest version of Webs Niagara N4 for CIPer Model 30
controller installation.
To Next Page
Loading...
