Honeywell CIPer 30 - Upgrade Method 1: Distribution File Installer; Required Distribution Files List

To Next Page

To Previous Page

CIPer

MODEL 30 CONTROLLER - INSTALLATION AND OPERATIONS GUIDE

31-00206 - 02

Install WEBStation-N4.10.0.154

Download and install WEBStation-N4.10.0.154 on your system.

Procedure to Upgrade CIPer Model 30 Controller and Expansion IO

Procedure 1: Distribution File Installer

Following are the dist files required to upgrade CIPer Model 30 controller and Expansion IO using the

Distribution File installer:

Files required for Distribution File Installer

Tools File Name Version

WEB-O3022H Firmware honeywell-IPCSIO.dist 1.1.0.76

WEB-O9056H Firmware honeywell-IPCIO.dist 1.1.0.140

Baseboard Firmware honeywell-IPCBASE.dist 1.1.1.146

OS QNX honeywell-IPCQNX.dist 7.0.4.4

JRE honeywell-azul-ejre-ipcqnx-arm.dist 1.8.0.282

IPC Tools honeywell-IPC-tool.dist 4.10.0.1.1.257

IPC Module honeywell-IPC-module.dist 4.10.0.154

Niagara Core Software nre-core-honeywell-IPCQNX-arm.dist 4.10.0.154.4

Niagara Config Software nre-config-honeywell-IPC.dist 4.10.0.154.6

NOTE

Factory Reset Image

• The honeywell-IPC-factory.dist file can be used to reset the CIPer Model 30 Controller to

factory settings. To install the honeywell-IPC-factory.dist file, use Distribution file installer.

• The factory reset image should only be installed after the upgrade process has been verified

successfully.

• At this time, installing the Factory reset is not possible with Commissioning Service and

Provisioning service

NOTE

Honeywell Buildings Forum access requires a valid login to download the software.

NOTE

• For upgrading all components in a single installation use nre-config-honeywell-

IPC.dist file. This file installs all of the individual components of CIPer Model 30 core

files, baseboard firmware, expansion IO firmware, and CIPer Model 30 modules.

Other manuals for Honeywell CIPer 30