Honeywell CIPer 30 - Upgrade Method 2: Commissioning Wizard; Commissioning Wizard Steps

CIPer
TM
MODEL 30 CONTROLLER - INSTALLATION AND OPERATIONS GUIDE
15
31-00206 - 02
Procedure 2: Using Commissioning Wizard
Following are the dist files required to upgrade CIPer Model 30 controller and Expansion IO using
Commissioning Wizard:
Files Required for Commissioning Wizard
Tools File Name Version
WEB-O3022H Firmware honeywell-IPCSIO.dist 1.1.0.76
WEB-O9056H Firmware honeywell-IPCIO.dist 1.1.0.140
Baseboard Firmware honeywell-IPCBASE.dist 1.1.1.146
OS QNX honeywell-IPCQNX.dist 7.0.4.4
JRE honeywell-azul-ejre-ipcqnx-arm.dist 1.8.0.282
IPC Tools honeywell-IPC-tool.dist 4.10.0.1.1.257
IPC Module honeywell-IPC-module.dist 4.10.0.154
Niagara Core Software nre-core-honeywell-IPCQNX-arm.dist 4.10.0.154.4
Niagara Config Software nre-config-honeywell-IPC.dist 4.10.0.154.6
Steps To Perform Commissioning Wizard
1. Log in to the Platform of the CIPer Model 30 using the WEBStation-N4- N4.10.0.154 workbench.
2. Run the Platform Administration from platform view.
3. Select Commissioning Wizard.
NOTE
Installing the honeywell-IPC-factory.dist file is not supported via commissioning.