TM
MODEL 30 CONTROLLER - INSTALLATION AND OPERATIONS GUIDE
37 31-00206 - 02
5. Configure Serial port setup and Enter the login credentials for platform
6. Click OK to Save the changes.
Reset to factory defaults
In case you forget the station credentials, you can reset to the factory defaults. Follow the below steps
to reset CIPer 30 controller to default factory setting. Since this operation is performed in bootloader,
the controller must be running in bootloader.
1. Connect the CIPer 30 controller with serial console using terminal emulators tool (for example
Putty).
Note:
The default baud rate of the CIPer Model 30 controller is 115200bps.
To Next Page
Loading...
