Honeywell CIPer 30 - Page 38

CIPer
TM
MODEL 30 CONTROLLER - INSTALLATION AND OPERATIONS GUIDE
31-00206 - 02
38
After configuring CIPer 30 controller with serial console, power cycle the device.
2. When system displays Hit any key to stop autoboot, type passphrase enters, and press Enter
key on the keyboard.
Note:
Complete the step (3) within 5 seconds. If fail to enter, system will continue autoboot.
This action redirects you to factory reset menu and conformation message is displayed “Are
you sure to reset to factory defaults? <Y/N>”