Honeywell CIPer 30 - Page 24

CIPer
TM
MODEL 30 CONTROLLER - INSTALLATION AND OPERATIONS GUIDE
31-00206 - 02
24
3. Drag the small Expansion IO device from the ipcProgrammingTool palette and configure the
model type as WEBO3022H and the address to what is configured on the DIP switches of the
expansion IO module. Make sure that the status shows OK and the firmware version shows
1.1.0.76 as seen below.
This completes the CIPer Model 30 WEBs-N4.10 version upgrade process