Honeywell CIU 888 - Page 11

CIU Emulation
Part No.: 4417589_Rev13 Protocol Manual - CIU Emulation
CIU 888 1 - 5
$*6
CIU Plus
On the HostPorts tab, set the type to None for the host port that must be
enabled for CIU Emulation (see FIGURE 1-4).
FIGURE 1-4 CIU Emulation - CIU Plus configuration settings
REMARKS: 1. Although each of the four host ports can be enabled for CIU Emulation, it is
recommended to reserve HostPort 1 for connecting to Entis Pro.
2. CIU Emulation can be configured on only one of the host ports of the
CIU 888. When configuring a new site, CIU Emulation is usually configured
on either HostPort 2 or HostPort 4. However, if a CIU 880 database is
migrated to the CIU 888, the configuration will depend on the CIU 880 Plus
host ports that were configured in the first place.