Honeywell CIU 888 - Page 21

Virtual Tunnel
Part No.: 4417589_Rev13 Protocol Manual - CIU Emulation
CIU 888 2 - 3
$*6
Perform the following steps to set up a virtual tunnel:
1. Connect the PC/laptop with Engauge installed to the Service port of
the CIU 888 using the Ethernet cable. The Service port is located at
the front of the CIU 888 (see FIGURE 2-2).
FIGURE 2-2 CIU 888: Service port
2. Launch Engauge by clicking Start > All Programs > Honeywell>
Configuration > Engauge.
When Engauge is launched, the Site Explorer window is displayed
(see FIGURE 2-3):
FIGURE 2-3 Engauge: Site Explorer window