Honeywell CK75 - About the I;O Cover on Non-Incendive Models

6 75 Series Mobile Computer User Guide
• DX1 Desktop Base (Model 1002UU01) with Battery Cup Model 1002UC02 and
power supply
• DX2 Dual Base (Model 1002UU02, 1002UU03) with Battery Cup Model
1002UC02 and power supply
• DX4 Quad Base (Model 1002UU04, 1002UU05) with Battery Cup Model
1002UC02 and power supply
You can charge a 1000AB02 battery installed in a CN75 or CN75e with these
accessories:
• DX1 Desktop Base (Model 1002UU01) with Computer Cup Model 1002UD01
and power supply
• DX2 Dual Base (Model 1002UU02, 1002UU03) with Computer Cup Model
1002UD01 and power supply
• DX4 Quad Base (Model 1002UU04, 1002UU05) with Computer Cup Model
1002UD01 and power supply
• Snap-On Adapters (Model 1000AA01, 1000AA02, 1000AA03, 1000AA04,
1000AA05, 1000AA06) and power supply
•Vehicle Power Adapter
You can charge a 1001AB01 battery installed in a CK75 with these accessories:
• DX1 Desktop Base (Model 1002UU01) with Computer Cup Model 1002UD02
and power supply
• DX2 Dual Base (Model 1002UU02, 1002UU03) with Computer Cup Model
1002UD02 and power supply
• DX4 Quad Base (Model 1002UU04, 1002UU05) with Computer Cup Model
1002UD02 and power supply
• Snap-On Adapters (Model 1000AA01, 1000AA02, 1000AA03, 1000AA04,
1000AA05, 1000AA06)
About the I/O Cover on Non-Incendive Models
An I/O cover is supplied with non-incendive versions of the CN75 and CN75e
computers. Non-incendive models can be identified by the device label verifying
non-incendive certification and a teal colored label on the front/top of the
computer. After charging the battery, always immediately install the I/O cover.
Warning: The I/O cover must be attached when using the CN75/CN75e NI in a
dangerous environment.
Avertissement : Le couvercle entrée-sortie doit être fi xé lorsque le CN75/CN75e
NI est utilisé dans un environnement incendiaire.