100 CN80 Mobile Computer Series User Guide
5. If prompted, enter additional information, and click Submit.
6. Select Download. Follow the prompts to download the file.
About Transferring Files via USB Connection
If you plan on using a USB connection to transfer the upgrade files to the mobile
computer, make sure you set the USB connection to allow file transfers. To learn
more, see Configure USB Connection and Transfer Files on page 32.
Install Software Updates with AutoInstall
Important: The Dolphin CN80 must have power for the entire length of the upgrade process or it
could become unstable. Do not attempt to remove the battery during the process.
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Settings > Honeywell Settings > Provisioning mode.
3. Tap the toggle button to turn Provisioning mode On.
4. Save the upgrade file (*.zip or *.apk) in one of the following folders on the CN80
mobile computer:
• Internal shared storage\honeywell\autoinstall
Software upgrades saved to this folder for installation do not persist when a
Full factory reset or Enterprise data reset is performed.
• IPSM card\honeywell\autoinstall
Software upgrades saved to this folder do not persist when a Full factory
reset is performed. However, the upgrade does persist if an Enterprise data
reset is performed.
5. Swipe up from the bottom of the Home screen to access all apps.
6. Tap AutoInstall Settings and Enable AutoInstall .
7. Tap Packages Update from the AutoInstall Settings screen.
The computer automatically initiates a reboot and installs the software
upgrade. The system update screen appears during the upgrade process. When
the update is finished, the lock screen appears.
8. Once installation is complete, turn Provisioning mode Off.
Note: Some updates do not require the computer to reboot before installation.
To Next Page
Loading...
