26 CN80 Mobile Computer Series User Guide
Turn the Heaters On/Off in Automatic Mode
When Automatic mode is enabled, you can still manually turn the heaters On or
Off while in cold storage.
Tap the snowflake or heater icon in the status bar.
•If Preemptive Heating is disabled, the heater Preemptive delay time is not
used and pre-heating does not automatically start, but the snowflake icon
can still be tapped to turn On the heaters for pre-heating.
•If you enabled Preemptive Heating, the heater Preemptive delay time stops
when the icons are used to turn the heater On or Off.
How Manual Mode Works
Manual mode gives you full control over turning the heaters On or Off.
When Manual mode is enabled, automatic cold storage enter/exit detection is no
longer used to control the heater behavior. To turn the heaters On or Off, you must
tap a button on the Heater screen in the Settings app. Full power is used for
defrosting. Manual mode is disabled by default.
Turn Manual Mode On/Off
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Settings > Heater.
3. Tap the Automatic/Manual button to switch between the Automatic or Manual
mode. The active mode appears on the button. When Manual mode is enabled,
the Heater On/Heater Off button next to the mode button is active.
4. Tap the Heater On/Heater Off button to control the heaters.
Configure the Heater in the Settings App
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Settings > Heater.
3. Modify the heater parameters.
4. Tap Update to apply the changes.
5. Tap OK.
Heater Parameters
You can configure the following Heater parameters in the Settings app to fit your
specific application environment.
To Next Page
Loading...
