28 CN80 Mobile Computer Series User Guide
Insert a microSD Card
You can use a microSD card to increase file storage capacity or to install software.
Honeywell recommends the use of Single Level Cell (SLC) industrial grade
microSD or microSDHC memory cards with the computer for maximum
performance and durability.
Note: Format the memory card before initial use.
1. Save your files and close any open applications.
2. Press and hold the Power button until the options menu appears.
3. Tap Power Off.
4. Release one end of the hand strap.
5. Slide the battery latch to the right.
Fast monitoring interval Set sampling interval time (seconds) used once the computer
detects cold storage entry. Cold storage entry is defined by the
Heater enabled temperature.
Slow monitoring interval Set sampling interval time (seconds) used once the computer
detects cold storage exit (defined by DeltaT value).
Disable temperature Set the temperature limit (°C) that triggers turning off the heater.
Blanking Tap check box to enable or disable heater operation during
scanning.
Update Tap to apply changes made to settings.
Default Tap to set the Heater settings back to their default values.
Heater Setting Description
Caution: Always power off the computer before attempting to install or
remove a card.
Warning: If you have a CN80 NI model certified for use in hazardous
locations, read About the optional Dust Cover on page 7.
To Next Page
Loading...
