EasyManuals Logo

Honeywell Code Encryptor II User Manual

Honeywell Code Encryptor II
24 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
Canadian Department of
Communications (DOC) Statement
NOTICE: The Canadian Department of Communications label identifies certified
equipment. This certification means that the equipment meets certain
telecommunications network protective, operational and safety requirements. The
Department does not guarantee the equipment will operate to the user's satisfaction .
Before installing this equipment, users should ensure that it is permissible to be
connected to the facilities of the local telecommunications company. The equipment
must also be installed using an acceptable method of connection. In some cases, the
company's inside wiring associated with a single line individual service may be
extended by means of certified connector assembly (telephone extension cord). The
customer should be aware that compliance with the above conditions may not prevent
degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian
maintenance facility designed by the supplier. Any repairs or alterations made by the
user to this equipment, or equipment malfunctions, may give the telecommunications
company cause to request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections
of the power utility, telephone lines and internal metallic water pipe system, if pres-
ent, are connected together. This precaution may be particularly important to rural
areas.
CAUTION: User should not attempt to make such connections themselves, but should
contact the appropriate electric inspection authority, or electrician, as appropriate.
The Load Number (LN) assigned to each terminal device denotes he percentage of
the total load to be connected to a telephone loop which is used by the device, to
prevent overloading. The termination on a loop may consist of any combination of
devices subject only to the requirement that the total of the Load Numbers of all the
devices does not exceed 100.
23

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell Code Encryptor II and is the answer not in the manual?

Honeywell Code Encryptor II Specifications

Power IconPower
receiver power input12VDC
stand by power consumption15ma
Operating Environment IconOperating Environment
temperature range-5°F to 160°F
range150+ feet
frequency303Mhz
Remote Control IconRemote Control
battery12VDC Mini (Part #GP23A)
battery replacement frequencyonce a year

Related product manuals