Honeywell Code Encryptor II User Manual

12
Panic Mode
Press and hold button 3 on the remote control for at least 3 seconds. This will cause
the panel to go into a panic mode. Press button 1 (largest button) to disarm the panel.
FOR DSC 1555/832 AND MOOSE ZX200/ZX400 YOU MUST ENTER
YOUR FOUR-DIGIT USER CODE TO CANCEL THE REMOTE PANIC. THE
REMOTE WILL NOT CANCEL A PANIC.
DEACTIVATING THE PANIC FEATURE:
In the event the user does not want to access a panic button through the remote
control, it can be de-activated from the Code Encryptor II’s memory.
Step 1) Unplug the wire harness from the Code Encryptor II.
Step 2) Press and HOLD the program button.
Step 3) While HOLDING the program button, plug the Code Encryptor II harness
back in. The LED light located on the front will turn ON.
Step 4) Wait until the light turns “OFF”.
Step 5) Once the light has turned “OFF” release the button

Honeywell Code Encryptor II Specifications

Power

receiver power input	12VDC
stand by power consumption	15ma

Operating Environment

temperature range	-5°F to 160°F
range	150+ feet
frequency	303Mhz

Remote Control

battery	12VDC Mini (Part #GP23A)
battery replacement frequency	once a year