Need help?Do you have a question about the Honeywell Code Encryptor II and is the answer not in the manual?
Power| receiver power input | 12VDC |
|---|---|
| stand by power consumption | 15ma |
Operating Environment| temperature range | -5°F to 160°F |
|---|---|
| range | 150+ feet |
| frequency | 303Mhz |
Remote Control| battery | 12VDC Mini (Part #GP23A) |
|---|---|
| battery replacement frequency | once a year |
Explains how to verify a four-digit user code for arming/disarming.
Details the procedure for teaching the Code Encryptor a user code using the program button.
Describes how to arm and disarm the system using remote buttons.
Details how to activate panic mode and disarm the panel using the remote.
Outlines steps to disable the panic feature from the Code Encryptor's memory.
Explains the default setting for activating panic mode and how to re-enable it.
Describes adding a remote using a keypad code and button presses.
Addresses issues where Button #1 on the remote has no effect.
Troubleshoots problems with the panic mode activation.
Solves problems with ARM/DISARM functionality on specific alarm panels.
To Next Page