Honeywell Code Encryptor II User Manual

TO DELETE ALL REMOTES
METHOD #1
To delete a lost or stolen remote from the Code Encryptor II, you must purge the
entire memory. This will delete all of the current remotes. You will then have to add
them back in one at a time. To purge the memory, disarm the panel. Enter 76278
from the keypad. The keypad on most panels will “beep” or the lights will turn off
momentarily to confirm delete. Follow the instructions on page 14 (To Add a New
Remote).
METHOD #2
To delete a lost or stolen remote from the Code Encryptor II, you must purge the
entire memory. This will delete all of the current remotes. You will then have to add
them back into memory. To purge, PRESS AND HOLD the program button, the
light will come ON for four seconds, then go OFF, and finally it will come ON again,
indicating that all the remotes in memory have been purged. Release the program
button and follow the instructions on page 14 (To Add a New Remote).
17

Honeywell Code Encryptor II Specifications

Power

receiver power input	12VDC
stand by power consumption	15ma

Operating Environment

temperature range	-5°F to 160°F
range	150+ feet
frequency	303Mhz

Remote Control

battery	12VDC Mini (Part #GP23A)
battery replacement frequency	once a year