2 - 12
Suspend Mode
In Suspend mode, the device enters a low power state to conserve battery power. The radio associated
with the phone maintains enough power to wake the terminal for incoming phone calls.
Suspend mode automatically turns the touch screen off to save battery power when the terminal is
inactive for a programmed period of time. The automatic timeout limits are adjustable from the
Advanced tab located under Settings > System > Power (see page 7-18).
To put the device into Suspend mode, press and release the Power key for approximately 4-5
seconds. To resume from the Suspend mode, press and release the Power key.
Replacing the Main Battery
Note: Before replacing the main battery, read the Guidelines for Battery Pack Use and Disposal on page 3-13.
Ensure all components are dry prior to mating terminals/batteries with peripheral devices. Mating wet
components may cause damage not covered by the warranty.
1. Remove the battery door, slide the latch to unlock the battery door, remove the battery door, then
remove the battery.
2. Insert the new battery, then attach and lock the battery door.
Note: Do not attempt to use the terminal without the battery door installed.
3. The terminal begins booting as soon as power is applied.
To Next Page
Loading...
