Dolphin® Power Tools User’s Guide Rev A
8/6/08
9 - 7
2. Click the Execute button. The Output tab appears displaying the network routing table.
3. This table displays Destination, Netmask, Gateway, Metric, and Interface columns. Scroll right to
see all the columns.
To Add a Route
You can add a custom route with the Add command.
1. On the Input tab, select ADD in the Command drop-down list. Fields appear on the Input tab.
2. Specify the range of IP address to which this rule will apply using the Destination and Netmask
fields. For example, the settings in the screenshot below specify an address range from 300.300.0.1
to 300.300.255.254.
3. Enter the Gateway.
4. Enter the Metric (not required).
5. Enter the Interface (not required).
To Next Page
Loading...
