1 - 4
Replacing the Main Battery Pack
Note: Before replacing the main battery pack, read the Guidelines for Battery Pack Use and Disposal on page 2-14.
Ensure all components are dry prior to placing the battery in the terminal. Mating wet components may cause
damage not covered by the warranty.
1. Press the Power key to put the terminal in Suspend Mode (see page 1-12).
2. Release the hook securing the hand strap to the back panel of the terminal near the speaker (99EX
models only).
3. Remove the battery door by lifting up the latches near the base of the battery door.
4. Wait at least 3 seconds, and then remove the battery. This process allows the device to shut down
properly and maintains memory during the battery swap.
5. Insert the new battery into the battery well.
6. Replace the battery door. Apply pressure to engage the door latch. The battery door must be
installed prior to powering the unit.
7. Reattach the hand strap.
We recommend use of Honeywell Li-poly or Li-Ion battery packs. Use of any non-Honeywell battery may result
in damage not covered by the warranty.
To Next Page
Loading...
Need help?
General