1 - 12
3. Select Perform Factory Reset from the menu, and then press ENT .
The following message appears on the terminal screen:
“All installed applications & customized settings will be deleted. Do you want to proceed?”
4. Press Y for yes, proceed with the Factory Reset.
If you change your mind and do not want to proceed, press N for no and the terminal will launch the
current image instead of a factory reset.
Suspend Mode
The terminal goes into Suspend Mode automatically when the terminal is inactive for a programmed
period of time. You can program this time on the Advance tab of the Power System Setting; see Power
on page 6-16.
To put the terminal into Suspend Mode manually, press the Power key and the screen turns off.
To wake the terminal from Suspend Mode, press the Power key or SCAN key .
Note: You should always put the terminal in suspend mode before removing the battery door. For information on
removing the battery, see Replacing the Main Battery Pack on page 1-4.
To Next Page
Loading...
