7 - 3
4. The IrDA port searches for a receiving IrDA port in the vicinity. The selected device reads “Pending.”
5. When the IrDA port finds the aligned IrDA port, it immediately starts sending the selected file. The
selected device reads “Sending.”
6. When the file transfer is complete, the selected device reads “Done.”
Receiving Data
The Beam Setting must be set to receive all incoming beams from other infrared devices.
1. Verify that beam settings are set to receive. Tap > Settings > Connections > Beam. The
Beam Settings window should appear as follows:
2. Align the IrDA ports.
3. Have the owner of the other device send the data to you.
4. Your terminal automatically begins receiving the data.
5. A popup message appears asking if you want to save the incoming file.
6. Tap Yes to receive the file.
To Next Page
Loading...
