Chapter 3 — About the Scanner
Dolphin CT50 Mobile Computer User Guide 41
Decode Settings
Use the Decode Settings to scan bar codes that are densely packed.
When enabled, the scanner will only decode a bar code is part of it is at
the center of the aimer. Although you can adjust the Window
dimensions, Honeywell recommends leaving the settings at 50 to define
the “center” area for the bar code.
Imager Settings
You should not need to modify the Imager Settings. The Override
Recommended Values setting is disabled by default. The recommended
Imager Settings are designed to work in a wide range of environments
and should only be modified if you have an advanced understanding of
imagers.
Trigger Settings
Use the Trigger Settings to configure how the scan buttons work.
Notification Settings
Use the Notification Settings to configure how your CT50 responds when
you scan a bar code.
Decode Settings
Setting Description Default
Center Decode Enables the ability for the scanner to
scan only the bar code at the center of
the aimer.
Disabled
Trigger Settings
Setting Description Default
Decode Timeout Scanning automatically turns off after this
number of seconds if the scan trigger is
pressed and nothing has successfully
decoded.
20
To Next Page
Loading...
