Chapter 4 — Use the Phone
Dolphin CT50 Mobile Computer User Guide 49
Activate the CDMA Phone
To activate the CDMA phone (Model CT50LFN) in your mobile computer,
you need to contact your wireless carrier and set up an account.
You also need to provide the carrier with the Mobile Equipment Identifier
(MEID) for the computer. You can find the MEID:
• on a label located in the battery compartment.
• on the outside of the computer shipping box.
The activation process is slightly different for each CDMA carrier. Your
carrier sales contact and an Honeywell representative can guide you
through the process. In general, you activate the CDMA phone as
follows:
1 Contact your wireless provider and give the provider the MEID for the
computer.
2 If your carrier is Verizon, tap , enter
*228 on the phone keypad,
and tap . After a short wait, a message appears, confirming either
success or failure of the activation. After successful activation, the
phone is ready to use.
Make a Phone Call
Once the phone is activated, you can make a phone call.
1 On the Home or All Apps screen, tap .
If the Phone app opens to a list of numbers instead of the keypad,
swipe left or touch to return to the keypad.
2 Touch the keys to enter the number, and then touch below the
keypad to dial.
3 To end a call in progress, tap .
Note: For the CDMA phone, settings are permanently stored in the
WWAN radio after activation. CDMA settings persist through a factory
data reset.
To Next Page
Loading...
