Chapter 6 — Configure the Computer
Dolphin CT50 Mobile Computer with Windows 10 IoT Mobile Enterprise User Guide 65
About Bluetooth Communications
The CT50 is Bluetooth-enabled, which lets you connect to other
Bluetooth devices. You need to turn on the Bluetooth radio before you
can discover and connect to other Bluetooth devices. By default, the
radio is turned off.
The Bluetooth radio maintains its current state through a system reset. If
you perform a factory data reset, you must recreate pairings to devices.
Connect a Bluetooth Device
To connect to a Bluetooth device, you must enable Bluetooth and then
select the device from a list of discovered devices.
1 Tap All Apps > Settings > Devices > Bluetooth.
2 Touch the toggle to turn on Bluetooth. A list of available Bluetooth
devices appears.
3 Tap the name of the device you want to pair with the CT50. As the
Bluetooth radio attempts to connect with the device, “Pairing”
appears under the name.
4 If the device requires a pin, do one of the following:
• Compare the pin displayed on both the computer and other
device in the Pairing accessory message box. If they match,
select OK.
• Enter the pin for the device and then select Done.
5 When the devices are paired successfully, “paired” appears under
the device name.
Disconnect a Paired Device
You can disconnect a paired Bluetooth device from the Settings app.
1 Tap All Apps > Settings > Devices > Bluetooth.
2 Touch and hold the name of the paired device and then select
Delete.
Note: If you are attempting to connect to a printer or a headset, the
default pin may be 1234 or 0000. If neither of these pin numbers work,
consult the device documentation for the pin number.
To Next Page
Loading...
