THE USERS MENU
The USERS item is a very important item in the menu, because all users must key in
their code or present their TAG in order to make any settings or adjustments to the
system or to access information about system status.
Note that some menus are only available using the Master Code or TAG.
ADDING OR MODIFYING CODES
You can add codes or modify existing codes, but all new codes must be at least 2
figures higher than any existing codes.
► For example, if a code for an existing user is 2345, you cannot allocate code 2346
to someone else, but 2347, 2348, etc.
To modify existing codes:
Select 1-CODES and press to see the list of users.
Enter the Master Code or present the Master TAG.
Select a user with , as shown in the first screen below.
Confirm your choice with or press to return to the menu.
A beep confirms your choice.
Press to confirm each screen or to cancel.
After the last screen, a tone confirms your settings.
CODES
1- USER 1
2- CHRISTOPHER
3- VIRGINIA
4- WILLIAM
5- SOPHIE
6- ETC...
CODES
CHRISTOPHER
AUTHORISE CODE?
NO YES
CODES
CHRISTOPHER
NEW : - - - -
Enter the code
Authorise the code
Select the user
CODES
1- USER 1
2- CHRISTOPHER
3- VIRGINIA
4- WILLIAM
5- SOPHIE
6- ETC...
15
To Next Page
Loading...
