17
REMOTE CONTROL OF APPLIANCES
This function allows you to control remote receivers.
Select 1-REMOTE PLUGS in the TOOLS menu, then select the name of the
receiver you wish to modify, using to move up and down.
Confirm your choice with
The screen displays one of the states below.
Confirm with
A keypad beep confirms the change of state of the remote receiver.
Press to return to the Tools menu.
THE TOOLS MENU
REMOTES
LAMP HALLWAY
< OFF >
NO YES
LOCATING TCU KEYPADS
If a second keypad has been misplaced, the SEARCH TCU test will cause a keypad
not located in its base to beep.
If you have only one keypad, this function is not active.
To locate the keypad by phoning the control panel:
Dial the telephone number of the panel.
After the music, enter your code.
A high-pitched tone confirms your code.
Press <* 55>, then hang up.
The missing keypad beeps.
To Next Page
Loading...
