3
Point Remote Gas Sensor User Manual
Introduction
Warnings
WARNING:
•
Install according to local electrical regulations and codes.
•
Installation should be performed by qualified personnel.
•
Do not paint over the sensor screen
•
Ensure that the sensor screen is free of dirt and debris.
•
Ensure that the sensor screen is not covered.
•
Do not expose the monitor to electrical shock and/or
continuous mechanical shock.
•
Do not expose the sensor to high-pressure water spray.
•
Do not use the monitor if it is damaged. Before use, inspect the
monitor. Look for cracks and missing metals or plastics. If the
monitor is damaged, contact Honeywell Analytics immediately.
•
The warranty will be voided if the customer or any unauthorized
service personnel attempt to repair the unit.
To Next Page
Loading...
Need help?
General
