3
Point Remote Gas Sensor User Manual
Description
Introduction
The E³Point Remote Sensor is a toxic or combustible gas detection
sensor that is compatible with the E³Point Standalone sensor. The
sensor provides continuous monitoring for one of the following gases
in ambient air: CO, H
2S, O2, NO2, and combustible hazards.
The E³Point is designed to be mounted on an extra wide (2 3/8”)
electrical box.
The E³Point Remote Sensor is intended for connection to E³Point,
Class 2, or limited power source (lps) only.
Safety Information
Users of the E³Point Remote Sensor require a full understanding of
the installation, operating, and maintenance instructions, otherwise
protection provided by the monitor may be impaired. Read the
following warnings before using the monitor.
Attention
This manual must be carefully followed by all individuals who
have the responsibility for using or servicing the sensor. Warranties
made by Honeywell Analytics with respect to this equipment will
be voided if the equipment is not used and serviced in accordance
with the instructions in this manual. Additionally, equipment
functionality and inherent protection may be compromised if this
manual is not carefully followed. If in doubt about a procedure,
contact Honeywell Analytics before proceeding.
To Next Page
Loading...
Need help?
General
