29
Setting preset heights for the work surface
Store up to three work surface heights in the work surface lift control
memory.
Each height is stored in a memory location. The 1, 2, and 3 buttons on
the work surface lift control represent each memory location.
Prerequisites
n The lift columns must be unlocked to store a work surface height,
or to move the work surface to a stored height.
To store a work surface in the work surface lift control
memory
1. Position the work surface to the required height.
The lift columns must be unlocked.
2. Press the S button on the work surface lift control.
“S” will appear on the work surface lift control display, and will
blink for three seconds.
3. While the work surface lift control display is blinking, press the 1,
2, or 3 button to store the work surface height.
“S1”, “S2”, or “S3” will appear for one second on the work surface
lift control display, depending on the memory button you pressed.
4. If you do not want to store a work surface height to a memory
location, press the up or down button.
To move the work surface to a stored height
1. Press and hold the 1, 2, or 3 button on the work surface lift
control.
2. Continue to hold the button until the work surface reaches the
stored height.
CAUTION: If you need to reset the lift columns, the operator
should never stay seated with their legs underneath the
work surface, as the columns may return to their lowest
position and could trap their legs between the chair and the
Chapter 3 - Installing an Experion Orion Console
To Next Page
Loading...
Need help?
General
