Honeywell Farenhyt ECS Series - Addressing SBUS Devices

ECS Series Manual — P/N 151455:H 2/15/2022 61
Addressing SBUS Devices ECS Device Installation
3. Attach strain relief clip to microphone cord. The strain relief clip should have about 2.75” of microphone cord through it. .
4. Push the strain into the hole in the dead front panel.
4.10.4 To Remove the ECS-RVM
To remove the ECS-RVM follow these steps:
1. Remove AC power and disconnect batteries from the main control panel.
2. Disconnect the SBUS connections from the SBUS terminals on the ECS-RVM. Refer to Figure 4.72.
3. Disconnect any devices connected to the VBUS. Refer to Figure 4.73 and Figure 4.74.
4. Unplug the microphone from the microphone connector. See Figure 4.75.
5. Remove the six 0.25” hex nuts that hold the ECS-RVM in place.
6. Lift the ECS-RVM off of the dead front panel.
4.11 Addressing SBUS Devices
When installing a hardware module (such as 5815XL, 6815, 5824, RA-1000, RA-100, RA-2000, 5496, RPS-1000, 5865-3 or 5865-4, ECS-
50W, ECS-125W, ECS-DUAL50W, ECS-VCM, ECS-NVCM and ECS-RVM), use the DIP switches on the module to assign an ID# to the
module.
Figure 4.77 shows all possible DIP switch positions and their correlation to a numerical ID. For example, to select ID 2, place DIP switch 2
in the up position.
1. 2.
Figure 4.76 Installing Strain Relief Clip
2.75”
14
5
2
3
14
5
2
3
*0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
14
5
2
3
1
4
5
2
3
24
25
26
27
28
29
30
31
16
17
18
19
20
21
22
23
Figure 4.77 Possible Module Addresses
ON
OFF
address address address address
*Address 00 is invalid
and cannot be used.