Testing Ethernet connection for FDAP2
A standard RJ-45 modular jack is available on the FDAP2 Power and IO board. The RJ-45
jack may be used to test cable integrity after terminating the cable at the IDC connector.
After terminating the field cable at the IDC, connect the cable tester to the RJ-45 jack. An
end-to-end cable test can then be performed to ensure proper wiring at the IDC connector.
Power on and startup
FDAP Gen3 and FDAP Gen3 Anchor
The FDAP Gen3 and FDAP Gen3 Anchor have one Ethernet cable and one power cable. has
six status LEDs to indicate the various stages of operation.
To Next Page
Loading...
