Honeywell Field Device Access Point - Page 40

FDAP CONFIGURATION
OWDOC-X256-en-323A
40
Device Management
Power
Displays the power supply status as Line
Powered (for access points) or Battery
Powered (for routing devices). By default,
power status is always Line Powered.
Routing
Assignment
Displays the routing configuration of the
device. The different types of configuration
are Non-Routing Device, Routing Device,
and Not Applicable. By default, Routing
Assignment is not applicable for FDAP and it
should not be changed.
Role Capability
Displays the capable roles of a device. By
default, FDAP can be an access point device,
if you enable over-the-air provisioning then
it can act as a provisioning device.
The different roles that can be configured
are Provisioning Handheld device, System
Time Source, Security Manager, System
Manager, Gateway, Access Point, Routing
Device, and I/O Device. If the Ethernet is
plugged, it acts as an access point and if the
Ethernet is unplugged, it acts as a routing
device.
Assigned Role
Displays the current assigned role of the
device.