1
Introduction
This technical manual is available in several languages and it covers the installation, operation and maintenance of the following
equipment:
FSL100-IR3 Flame Detector (Triple Infrared)
FSL100-UV Flame Detector (Ultraviolet)
FSL100-UVIR Flame Detector (Ultraviolet and Infrared)
FSL100-TL Test Lamp, Charger and Case (Safe Areas)
FSL100-TLX Test Lamp, Charger and Case (Intrinsically safe – IECEx, ATEX)
FSL100-SM21 Swivel Mounting
1.1 Intended Readers
This Manual should be read by everyone who operates or monitors the FSL100 Flame Detection system.
Only personnel who have been fully trained by Honeywell are authorised to Install, Set-up, Service, and Test, Repair, or
Recondition Honeywell flame detection systems.
To Next Page
Loading...
