Honeywell Genesis 7580G - Page 168

11 - 14
Telepen Default All Telepen
Settings
TELDFT 6-18
*Off TELENA0 6-18
On TELENA1 6-18
Telepen Output *AIM Telepen Output TELOLD0 6-18
Original Telepen Output TELOLD1 6-18
Telepen Message Length Minimum (1 - 60) *1 TELMIN## 6-18
Maximum (1 - 60) *60 TELMAX## 6-18
UPC-A Default All
UPC-A Settings
UPADFT 6-19
Off UPAENA0 6-19
*On UPAENA1 6-19
UPC-A Check Digit Off UPACKX0 6-19
*On UPACKX1 6-19
UPC-A Number System Off UPANSX0 6-19
*On UPANSX1 6-19
UPC-A 2 Digit Addenda *Off UPAAD20 6-20
On UPAAD21 6-20
UPC-A 5 Digit Addenda *Off UPAAD50 6-20
On UPAAD51 6-20
UPC-A Addenda Required *Not Required UPAARQ0 6-20
Required UPAARQ1 6-20
UPC-A Addenda
Separator
Off UPAADS0 6-20
*On UPAADS1 6-20
UPC-A/EAN-13 with Extended
Coupon Code
*Off CPNENA0 6-21
Allow Concatenation CPNENA1 6-21
Require Concatenation CPNENA2 6-21
Coupon GS1 DataBar Output GS1 Output Off CPNGS10 6-21
GS1 Output On CPNGS11 6-21
UPC-E0 Default All UPC-E
Settings
UPEDFT 6-22
Off UPEEN00 6-22
*On UPEEN01 6-22
UPC-E0 Expand *Off UPEEXP0 6-22
On UPEEXP1 6-22
UPC-E0 Addenda Required Required UPEARQ1 6-22
*Not Required UPEARQ0 6-22
UPC-E0 Addenda Separator *On UPEADS1 6-23
Off UPEADS0 6-23
UPC-E0 Check Digit Off UPECKX0 6-23
*On UPECKX1 6-23
UPC-E0 Leading Zero Off UPENSX0 6-23
*On UPENSX1 6-23
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric entry
Page