1 - 4
USB Interface with EAS
1. Connect the appropriate interface and EAS cable to the device, and then to the computer.
2. The scanner beeps.
3. Verify the scanner operation by scanning a bar code from the Sample Symbols in the back of this manual.
The unit defaults to a USB PC Keyboard. Refer to page 2-3 for other USB terminal settings.
For additional USB programming and technical information, refer to “USB Application Note,” available at www.honey-
wellaidc.com.
USB with EAS Connection:
Close-up of EAS
Connection:
Checkpoint
Wires
To Next Page
Loading...
