Honeywell Granit 1911i - Scanner Report; Scanner Address; Base or Access Point Address

3 - 12
The number of beeps and LED flashes emitted by the CCB01-010BT base
for an error condition can be programmed from 1 - 9. For example, if you
program this option to have five error beeps, there will be five error beeps
and five LED flashes in response to an error. To change the number of
error beeps, scan the bar code below and then scan a digit (1-9) bar code
and the Save bar code on the Programming Chart inside the back cover of
this manual.
Default = 1.
Scanner Report
Scan the bar code below to generate a report for the connected scanners. The
report indicates the port, work group, scanner name, and address. To assign a
name to your scanner, refer to Menu Command Syntax, page 11-1.
Scanner Address
Scan the bar code below to determine the address of the scanner you are
using.
Base or Access Point Address
Scan the bar code below to determine the address of the base or Access Point
you are using.
Number of Base Error Beeps/LED Flashes
Scanner Report
Scanner Address
Base Address