Honeywell Granit 1980i - Granit 1980 i Industrial Full Range Corded Scanner Product Specifications

Xenon/Granit User Guide 281
Suffix Add Suffix SUFBK2## 153
Clear One Suffix SUFCL2 153
Clear All Suffixes SUFCA2 153
Function Code Transmit *Enable RMVFNC0 154
Disable RMVFNC1 154
Intercharacter Delay Range 0 - 1000 (5ms increments) DLYCHR## 154
User Specified
Intercharacter Delay
Delay Length
0 - 1000 (5ms increments)
DLYCRX## 155
Character to Trigger Delay DLY_XX## 155
Interfunction Delay Range 0 - 1000 (5ms increments) DLYFNC## 155
Intermessage Delay Range 0 - 1000 (5ms increments) DLYMSG## 156
Data Formatter Selections
Data Format Editor *Default Data Format (None) DFMDF3 158
Enter Data Format DFMBK3## 159
Clear One Data Format DFMCL3 159
Clear All Data Formats DFMCA3 159
Data Formatter Data Formatter Off DFM_EN0 173
*Data Formatter On,
Not Required,
Keep Prefix/Suffix
DFM_EN1 174
Data Format Required,
Keep Prefix/Suffix
DFM_EN2 174
Data Formatter On,
Not Required,
Drop Prefix/Suffix
DFM_EN3 174
Data Format Required,
Drop Prefix/Suffix
DFM_EN4 174
Data Format Non-Match Error Tone *Data Format Non-Match Error
Tone On
DFMDEC0 174
Data Format Non-Match Error
Tone Off
DFMDEC1 174
Primary/Alternate Data Formats Primary Data Format ALTFNM0 175
Data Format 1 ALTFNM1 175
Data Format 2 ALTFNM2 175
Data Format 3 ALTFNM3 175
Single Scan Data Format Change Single Scan-Primary
Data Format
VSAF_0 175
Single Scan-Data Format 1 VSAF_1 175
Single Scan-Data Format 2 VSAF_2 175
Single Scan-Data Format 3 VSAF_3 176
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric
entry
Page