Performance Series IP Camera Software Configuration Guide
88
Figure 8-7 Access List
General Settings
Maximum number of concurrent streaming: Simultaneous live viewing for 1~10 clients
(including stream 1 to stream 3). The default value is 10. If you modify the value and click
Save, all current connections will be disconnected and automatically attempt to re-link (IE
Explorer or Quick Time Player).
Filter
Enable access list filtering: Check this item and click Save to enable the access list filtering
function.
Filter type: Select Allow or Deny as the filter type. If you choose Allow Type, only those clients
whose IP addresses are on the Access List below can access the camera, and the others
cannot. On the contrary, if you choose Deny Type, those clients whose IP addresses are on the
Access List below will not be allowed to access the camera, and the others can.
You can add a rule to the following Access List.
Single: This rule allows the user to add an IP address to the Allowed/Denied list.
Network: This rule allows the user to assign a network address and corresponding subnet
mask to the Allow/Deny List. The address and network mask are written in CIDR format.
Range: This rule allows the user to assign a range of IP addresses to the Allow/Deny List.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
