Configuring Camera Settings
37
Figure 4-16 Audio
Mute: Check to disable audio transmission from the Network Camera to all clients.
Internal microphone input gain: Select the gain of the internal audio input according to
ambient conditions. Adjust the gain from 0% (least) to 100% (most).
Audio type: Select audio codec as G.711 or G.726 and the bit rate.
• G.711 provides good sound quality and requires about 64Kbps. Select pcmu (μ-Law) or
pcma (A-Law) mode.
• G.726 is a speech codec standard covering voice transmission at rates of 16, 24, 32, and
40kbit/s.
After you complete the settings on this page, click Save to enable the settings.
Configuring Digital PTZ Settings
This section describes how to control the camera’s digital Pan/Tilt/Zoom operation.
Within a field of view, it allows you to quickly move the focus to a target area for close-up
viewing without physically moving the camera. You are still able to digitally zoom and navigate
the camera’s viewable area.
Go to Setup Camera Setup PTZ Settings.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
