Honeywell HEIPTZ-2201W-IR - Page 32

Honeywell
25
Figure 4-16
 Exposure mode: Exposure mode include Full-automatic/ Shutter Priority/ Anti-Flicker, default is Full-
automatic. When select Full-automatic or Anti-Flicker, the shuttle value can not be setted, and when select
Shutter Priority, the shuttle value can be setted.
 AGC: Low/ Mid/ High selectable, default is High. The bigger of the gain value, the higher of the low
illumination sensitivity, and the more obvious of noisy point
 Shutter: 1/10000~1/1，the smaller of the shutter value, the darker of the brightness
 Color-mode: Normal/ Bright/ Nature selectable, default is Normal
 WB mode: Auto WB/ Inside/ Outside selectable, select different white balance mode according to different
scenes, default is Auto WB
 Mirror: Normal/ Horizonal Mirror/ Vertical Mirror/ 180 rotation selectable, default is Normal
 Backlight mode: Close/ WDR/ Backlight correction selectable, default is Close
 Intensity： Low/ Mid/ High selectable. It is invalid when Backlight mode set close
 Dark compensation: Close/ Low/ Mid/ High selectable, default is Mid
 DNR mode: Close/ Low/ Mid/ High selectable, default is Mid
 Zoom rate: Show/ Hide selectable, set the zoom rate and view the corresponding effect on the screen
interface
 Coordinate: Show/ Hide selectable, set the zoom rate and view the corresponding effect on the screen
interface
 Status: Show/ Hide selectable, set the zoom rate and view the corresponding effect on the screen interface
 Zoom speed: Low/ Mid/ High selectable, default is High
 Anti-shake: Close/ Open selectable, default is Close
 Slow shutter: Close/ 2X--60X selectable, the bigger of the slow shutter value, the brighter in low illumination
environment
 Defogging: Close/Open selectable，default is Close