Honeywell HEIPTZ-2201W-IR - Motion Detection Configuration

Operation
26
 Day-Night Mode:Auto/Color/Black White selectable,default is Auto.According to the IP camera type and
using actual scene, user can select day & night switch mode optional.
After all parameters setting completed, click “Save” and the it comes into effect immediately.
Motion Detection
Network High Speed Dome “Motion Detection” setting interface as figure 4-17.
Figure 4-17
 Enable: Select whether open the motion detection function.
 Alarm Schedule: Set the alarm schedule from Monday to Sunday.
 Drawing: Click Drawing, then set the detective area.
 Clear: Click Clear to clear the current detective areas.
 Sensitivity: The higher of the sensitivity, the obvious of the motion detective.
 Email: Send Email to appointed mailbox when alarm triggered.
 Snap: Snapshot and install the picture in the HDD when alarm triggered.
 Alarm Output: There is a warner connect the alarm output port, alarm triggered the embedded relay switch
to make alarm output.
 Enable PTZ: Alarm input to link the PTZ motion.
 Preset: Alarm input to link the preset.
 Snap Interval: Set the snapshot interval time
 Snap Count: Set the snapshot count in every second
After all parameters setting completed, click “Save” and the it comes into effect immediately.