Honeywell HEIPTZ-2201W-IR - Platform Integration Management; Multicast Streaming Setup

Operation
28
Figure 4-19
 IPV4: IP protocol version No. is 4
 IPV6: IP protocol version No. is 6
 Static IP: The device IP address is permanent
 DHCP: Click DHCP, when turn on the router’s DHCP, the camera will get the IP address from router
automatically
 IP address: Input the corresponding numbers to change the IP address
 Subnet Mask: Input the corresponding IP subnet mask
 Gateway: Input the corresponding gateway address
 DNS1: DNS server address
 DNS2: DNS server standby address
 SNMP: To detect whether it will cause any management attention as device connected on the network
 SNMP Manager IP: Input the corresponding SNMP manager IP address
 HTTP Port: Input the corresponding port ( Default is 80)
 HTTPS Port: Input the corresponding port ( Default is 4433)
 Enable UPnp: When click Enable UPnp, the device and HTTP port will mapping to the router automatically
 Device Port: Input the corresponding device port (Default is 5050)
 Enable PPPOE: Click to enable PPPOE server
Username: Input the username
Password: Input the password
Confirm pwd: Input the password again to confirm it
PPPoe IP:Display the IP address
After all parameters setting completed, click “Save” and the it comes into effect immediately.
Platform Management
Network High Speed Dome “Platform Management” interface as figure 4-20.