9
USE AND OPERATION (CONTINUED)
EN
FUNCTION BUTTONS (CONTINUED)
SLEEP MODE
The Timer is adjustable between 1 - 24 hours.
AUTO TURN OFF:
While unit is running, press the Timer button and the display will flash. While the display is
flashing, press the or button to select the number of hours you want the unit to turn OFF
automatically.
AUTO TURN ON:
When unit is in a standby mode (plugged in with power light on), press the Timer button
and the display will flash. While the display is flashing, press the or button to select the number
of hours until you want the unit to turn ON automatically.
TIMER CONTROL
When the Sleep Mode is activated in Air Conditioning mode, the set temperature will increase by 1°C
or 1°F after the first hour of cooling and will increase a further 1°C or 1°F after the second hour of
cooling. The unit will maintain this temperature for 5 hours. The set temperature will then reduce by
1°C or 1°F on the seventh hour and reduce a further 1°C or 1°F on the tenth hour. Sleep mode will
then deactivate automatically.
Note: The Sleep Mode can be deactivated during cooling mode by pressing any button at any time.
Condensation may accumulate in the unit.
If the internal tank is full, error code "P1" will be displayed and an alarm will beep for 30 seconds.
The unit will not operate until the water has been drained from the lower drain plug (refer to Water
Condensation Drainage).
After switching the Local Air Conditioner off, the compressor will not start immediately. You must
wait about 4 minutes before it switches back on again.
WATER FULL ALARM
To Next Page
Loading...
Need help?
General
