10EN
USE AND OPERATION (CONTINUED)
REMOTE CONTROL
All key functions can be accessed from the remote control.
Use only two AAA or IEC R03 1.5V batteries.
Remove the batteries if the remote control is not in use for a month or longer.
All batteries should be replaced at the same time, do not mix with old batteries.
Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
Properly dispose of used batteries.
•
•
•
•
•
Caution:
°F
°C
Power Control
ON / OFF
Temperature Control
When the or
key is pressed,
the set temperature is displayed
and may be adjusted
•
•
•
Sleep Control
Swing Control
In running mode: Auto switch off
In stand-by mode: Auto switch on
Press or
button to adjust the
time setting for 1 hour intervals.
Timer setting is available from 1 - 24
hours by pressing the key or
.
When timer is set, press the or
key will cancel the timer setting.
Mode Control
• HIGH • MID • LOW • AUTO
ON / OFF
Press button to enable air outlet
louver swinging up and down. Press
button again to disable the swing
function. Swing can only be set from
the remote control.
Press button to change the
operation mode in the order of:
Fan Speed Control
Timer Control
Note:
Battery Installation: Remove the cover on the back of the remote control and insert two AAA
batteries with + and - pointing in the proper direction according to the polarity markings.
•
Air Conditioning
Dehumidifying
Auto
Fan
To Next Page
Loading...
Need help?
General
