Configuring System Settings | 117
800-19403 - A - 12/2014
To configure the network settings without the ATM/POS protocol
1. Go to Main Menu > Setting > System > Card Overlay > Net.
2. On the Net tab, configure the following settings:
3. Click Apply, and then click Save to save the settings.
•Protocol Select POS.
• Overlay Channel
Select a camera.
•Overlay Mode
The
Preview
and
Encode
overlay modes are enabled by default.
Clear the check boxes if you want to disable them.
•Overlay Position
Select
Top Left
,
Bottom Left
,
Top Right
, or
Bottom Right
.
• Source IP/Port
Enter the source IP and port. The source IP refers to the host IP
address that sends out the information.
• Destination/Port
Enter the destination IP and port. The destination IP refers to the IP
address of the device that receives the information.
To Next Page
Loading...