Honeywell IFP-2100ECS

To Next Page

To Previous Page

ECS Device Installation 151455

4-9

9. Reconnect backup batteries

Figure 4-14 Wiring Harness Connection for NVCM to IFP-300ECS

Figure 4-15 Connection between ECS-EMG and One ECS-SW24

FACP

NVCM

Main Page

Table of Contents5
Overview8
Optional Accessories8
Features9
Terms Used in this Manual10
Agency Listings, Approvals, and Requirements11
Federal Communications Commission (FCC)11
Underwriters Laboratories (UL)12
Requirements for All Installations12
Requirements for Central Station Fire Alarm Systems12
Requirements for Local Protected Fire Alarm Systems12
Requirements for Remote Station Protected Fire Alarm Systems13
Requirements for the Installation of Carbon Monoxide (CO) Detection and Warning Equipment, NFPA 72013
Installation14
Environmental Specifications14
Wiring Specifications14
Electrical Specifications18
Installing ECS-Series Cabinets18
Preventing Water Damage18
Surface Mounting the IFP-100ECS, IFP-1000ECS, IFP-300ECS, IFP-2100ECS or ECS-LOC Cabinet18
Surface Mounting the IFP-2000ECS or ECS-LOC Cabinet19
Surface Mounting the IFP-300ECS Cabinet21
Surface Mounting the IFP-2100ECS or ECS-LOC2100 Cabinet22
Surface Mounting Instructions22
Recessed Mounting Instructions23
Cabinet Door and Dead Front Removal for IFP-100ECS, IFP-1000ECS and IFP-2000ECS24
Cabinet Door and Dead Front Removal for IFP-300ECS and IFP-2100ECS25
ECS Device Installation26
Connecting AC Power and Batteries26
Installing the ECS-VCM26
ECS-VCM Board Layout26
Connecting the ECS-VCM to the SBUS27
Installing and Connecting the ECS-VCM to the ECS-SW2428
Installing the Microphone30
Installing the ECS-NVCM31
ECS-NVCM Board Layout32
Installing and Connecting the ECS-EMG to the ECS-SW2433
ECS-NVCM Fiber Modules36
Installing the Microphone36
Installing the ECS-50W or ECS-50WB38
ECS-50W Board Layout38
Mounting the ECS-50W39
Wiring Specifications40
Speaker Wiring41
Wiring Lengths42
Class B Speaker Configuration42
Class a Speaker Configuration43
VBUS Wiring43
SBUS Wiring45
Connecting AC Power46
Backup Battery for ECS-50W48
Calculating Current Draw and Standby Battery49
Installing the ECS-INT50W49
Board Layout & Mounting49
Mounting the ECS-INT50W50
Wiring to a FACP52
VBUS Wiring52
Setting the Device Address54
Speaker Wiring54
Calculating Current Draw and Standby Battery54
Installing the ECS-125W55
ECS-125W Board Layout55
Mounting the ECS-125W56
Mounting the ECS-125WBD Board Only56
Wiring Specifications58
Speaker Wiring60
Wiring Lengths60
Class B60
Class a61
VBUS Wiring61
SBUS Wiring63
Connecting AC Power65
Backup Battery for ECS-125W65
Calculating Current Draw and Standby Battery67
Installing the ECS-DUAL50W or ECS-DUAL-50WB68
ECS-DUAL50W Board Layout68
Mounting the ECS-DUAL50W68
Mounting the ECS-DUAL50WBD Board Only69
Wiring Specifications70
Speaker Wiring72
Wiring Lengths72
Class B Speaker Configuration for ECS-Dual50W72
Class a Speaker Configuration for ECS-Dual50W73
VBUS Wiring73
SBUS Wiring76
Setting the ECS-DUAL50W Mode79
Test Switch Use79
Sw1 - Amp a79
Sw2 - Amp B79
Connecting AC Power79
Backup Battery for ECS-DUAL50W80
Calculating Current Draw and Standby Battery81
Installing the ECS-50WBU82
ECS-DUAL50W Board Layout82
Installing the ECS-CE484
Installing the ECS-RVM85
ECS-RVM Board Layout85
Wiring the ECS-RVM86
Installing the Microphone87
To Remove the ECS-RVM88
Addressing SBUS Devices91
Panel Security92
Honeywell Fire Product Warranty and Return Policy94
Manufacturer Warranties and Limitation of Liability95

Honeywell IFP-2100ECS - Page 34

Table of Contents

Other manuals for Honeywell IFP-2100ECS

Related product manuals