Honeywell GmbH 10 MU5H-1419GE23 R0815
20. Push again until the display shows "RINSE".
Allow the rinse cycle to run its full course.
21. While the rinse cycle is finishing, load brine tank with salt.
22. If the refill cycle is at the end of the regeneration cycle,
add around 10 liters of water to allow the first regenera-
tion.
23. Go to section “Programming - Advanced Installers” on
page 13.
7.2. Valve positions
The bypass valve provided by with the KS20S softener can
be set into four different positions depending on the selected
mode. The following four images depict the valve positions
and the water ways (in/out) within the valve.
Img. 3 Normal position operation
Img. 4 Bypass position
Img. 5 Diagnostic position
Img. 6 Shut-off position
To Next Page
Loading...
Need help?
General
